![]() ![]() We have some MX4000's that also claim 4 ohm stereo (8 bridged) on the back panel, but 2 (4) ohms in the manual. The 'a' has only half the number of output transistors!! Regards, Phil Ralph Staub 05:11. The 1500a is quite different to the 1500. However, there are warnings in both manuals that such operation may cause problems with overheating and current limiting - this is under the heading of 2 ohm load operation, which is the same as 4 ohms in bridge mode. ![]() 'Byron Walker' wrote in message manuals I have show both amps as rated at 1500 watts into 4 ohms in bridge mode. The MX 1500a looks enough different that I don't want to assume they are set up the same way. Does anybody know what the volume knob settings on the 1500 should be when set to run bridge mono? I have been unable to locate a manual for these amps. In bridge mono mode the 1500s I have say on the back they will run at 4 ohms. These seem to be different than the MX 1500a (most likely older).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |